Complete Power Bench® with Extra Extension Table (18’ 6” long)

The Complete Power Bench® with Extra Extension Table is not just a saw stand but also a total work system.  That sets up in less than a minute! This configuration comes with the Basic Power Bench® 6 extra legs, 2 56” Extensions, 1 Stop Rail (Saw Not Included). This Complete Power Bench® is 18 foot 6 inches long with the Extension and has 8 outer legs total. It has 6-height settings that are adjusted with spring-loaded pins.  It is adjustable from 30 to 41 inches high.  So you can always work at the right height.

The center table is made of 1 inch square tubing and has a triangular cut-out hand hold that is set back so you never pinch your fingers and has pins to control the height underneath the number 9 mesh table top.  The mesh won’t burn and also lets metal filings and dust fall to the floor so as to not pile up on the bench.

There are adjustable collars to fine tune to match your miter saws.  Fine tune to your tallest saw.  Put spacers on your metal chop saws or any thinner tools, so all your tools are the same height so you just have to trade one from the other. X legs are made out of 11-gauge 1 inch square tubular steel and are nearly 1/8 inch thick and are adjustable to set flat on your uneven floor.  They can handle heavy loads like 2 7/8 inch oil field pipe. Drop legs are made with 1 inch square outer tubing, ¾ inch square tubing that drops to level up on uneven ground.  Adjusted by a metal T-handle made with a grade 5, 3/8 inch bolt.

Wings are made out of 1 inch square tubing with ¾ inch cross members that give you a ladder like look that’s open so people don't pile stuff in your way.  There are spring-loaded pins on each end that the two outer drop legs attach the Extension to the Basic Bench.  Left open they are an excellent welding table with great places to clamp what you're welding.  Or, you can add plywood over top to make them a solid bench if you wish for a mechanic’s bench or we also sell spring-loaded rollers that can be added if you wish for a roller bench.  It takes 6 short rollers and 6 long rollers for the Complete Power Bench® with extra extensions.

The Complete Power Bench® with extra extensions has four drop legs on one side and 4 drop legs on the other that are adjustable to match the terrain so you still have a flat plain to work on. The stand weighs approximately 95 pounds.  But, you only lift half at a time. Since it rolls on wheels you can tip load it into a truck box.  The extensions are a separate piece. The wheels are 8 inch, good quality grade rubber lawn mower wheels with metal hubs and bearings and won't go flat. Stop rails are made of 3 telescoping tubes that work right or left handed and extend beyond the Power Bench® for even longer multiple cuts. You can add a dock plate to turn them into a handcart.

The Complete Power Bench® with Extra Extension Table includes:

• Black powder coat finish
• 6 extra legs
• 2 - 56” extension table (longest in the industry)
• 1 stop rail
• Extensions on both sides (fit each end only)
• Industrial strength adjustable work bench
• Handles metal chop saws
• Saw not included

WATCH VIDEO for quick, easy setup of the Complete Power Bench® known as the best miter saw stand and total work system.